Post view

Roller Shutter Tubular Motor Manufacturers Introduces The Installation Knowledge Of The Wiring Of The Electric Screen

Roller Shutter Tubular Motor Manufacturers introduces the installation skills of the wiring position of the electric screen:

1. From the perspective of home use: tend to be installed below. It can be connected with other electrical appliances or plug-in boards when needed. It is not recommended to install on the top. This is neither beautiful, but also saves the budget for hydropower transformation. Objectively speaking, compared with the decoration value of your entire room, the telescreen is only a small part. The east-west door of this value does not need to be installed at a height. In the future, if the room cover is higher than the board, the possibility of use will be too small

2. Install the socket in an inconspicuous place: Depending on the position of the socket, there may be other electrical appliances nearby to supply power to the screen. At least 5 holes. In a few years, you won't like telescreens anymore. If you want to replace it, this circuit can be used for other purposes. Sometimes it can also be used as a power source for air conditioners. Of course, in this case, we need to lay a larger diameter wire.

3. The choice of socket location: curtains hung on the wall, adjacent corners. If the telescreen blocks the teahouse, it will be very uncomfortable.

Wiring skills of different types of telescreens:

Electric screen with remote control only: If you only need remote control, just ask the electrician to leave a potential in your curtain box or close to the curtain installation surface, and install a socket (just like reserving an air-conditioning socket), but you need to pay attention However, the bottom box should be a type 86 (non-standard external) plastic bottom box, which is relatively larger than an ordinary family) iron bottom box.

Electric screen with remote control and manual control panel: Let the electrician give you a potential on the wall that you think fit and beautiful-pay attention to the bottom box requirements above. In addition, lead out the three-core wire from the position where you place the bottom box (single-track root, two-track requires two) Note: Each automatic curtain track motor must be connected to a three-core wire, and the zero wires of the two-track motors cannot be shared!

It should be said that the wiring work of the electric screen is an important part of the installation of the electric screen. Before installation of the electric screen, the arrangement of the power line and control line of the electric screen should be reasonably arranged to make the room beautiful. The telescreen can make our lives more comfortable, so we don't have to worry about closing the curtains when we sleep. The remote control can solve this problem.

Through the above introduction, Roller Blinds Motor Manufacturers hopes that you can simply refer to the content of this article in future use.

wistarmotor · 83 days ago
Comments
Order by: 
Per page: 
 
  • There are no comments yet
Post info
Actions
Rate
0 votes
Recommend
 
Categories
Lifestyle (2 posts)
Miền Nam (1 posts)
Tin tức (1 posts)
Roller Shutter Tubular Motor Manufacturers Introduces The Installation Knowledge Of The Wiring Of The Electric Screen